Topcon HiPer Ga, Operator'S Manual

Page: 41 / 162

Charging the Internal Batteries
P/N 7010-0816
2-7
Figure 2-5. Extract Program and Create Shortcut
To uninstall FLoader, navigate to the location of the *.exe file, select
the file, and press
Delete .
Charging the Internal Batteries
Before using the HiPer Ga/Gb, fully charge the batteries for
maximum operating time (Figure 2-6 on page 2-9).
With a full charge, the internal batteries should power the GPS
receiver, the Bluetooth module, and the Digital UHF radio modem
transmitting data at 1 W for at least 8
hours operating in receiver
mode; the internal batteries should power the receiver for 10 hours. If
the internal radio modem is turned off, the HiPer Ga/Gb should run at
least 12 hours with fully charged on-board batteries.
To charge the batteries:
1. Connect the power cable to the power supply unit.
2. Connect the SAE connectors on the power adapter cable and
power supply unit.
NOTE
The batteries are shipped from the factory without
power. Fully charge the batteries before surveying.