2025001032 Revision L, 10/16
15
4.
ASSEMBLY - FOR AIT-W1/W2 ONLY
NOTE:
Both AIT-W1 and AIT-W2 Tables arrive pre-assembled in shipping box.
4.1
Table System
1.
Unpack the AIT-W Table and allow the unit to come to room temperature.
Use Figure 1.2 to identify the main components.
2.
Move the table to the desired location in the room by lifting the side of the tabletop.
Place the back of the table close/flush to the wall.
NOTE: At least two people should perform this task.
If moving the table to a far location, a dolly is recommended to be used,
Figure 4.1: Unpacking AIT-W
(AIT-W1 is shown in this Figure)
3.
Plug power cable to outlet. Using the switch panel, operate the table up/down to move it into desired
height position setting, using the up/down arrow respectively.
If table reset is needed, perform system initialization procedure in Section 6.6.
More functionalities of the switch panel can be found in System Operation Section 6.
Figure 4.2: Operating AIT-W
(AIT-W2 is shown in this Figure)
