17
2.8 G92——Set Coordinates
Format: G92 X_ Y_ Z_ C_
Note: Set current location as new coordinates
3.M Code
M code is used to control input and output.
Code
Functions
M02
Program End
M03
Spindle clockwise spinning
M04
Spindle counter clockwise spinning
M05
Spindle Stop
M51~M66
Corresponding output port open or close
EX:
（
1
）
First find
PAR
-
Output
, input Output 1 for M51; then press
Enter
to turn “Off” to “On”; Press
ESC
,
Then press
Enter
to save.
（
2
）
Press
PROG
, then
New
, type in a name, then press
ENTER
, and then you can start to edit;
N001 M03 S200
Spindle spin clockwise at 200r/min
N002 G04 K5
Delay 5s
N003 G01 X100 Y100 F1500 Linear Interpolation
N004 M04 S200
Spindle spin counter clockwise at 200r/min
N005 G04 K5
Delay 5s
N006 G01 X50 F1500 Linear Interpolation
N007 M05
Spindle stop
N008 M51
Output port 1 is connected
N009 M02
Program End
（
3
）
After finishing edition, press
Save
, then press
AUTO
and
Start
to run.
4.Spindle
S code is used to control the speed of the spindle, this controller use analog voltage controlling method to
control spindle speed.
Note: S code can not support power off memory.
EX: N001 M03 S1000
Spindle spin clockwise at 1000r/min
Summary of Contents for TC55H
Page 20: ...jiafengqi xtf hotmail com 20 ...
