3
6. Remounting covers, and lock it.
3. Push out the front cover from back cover.
5. Place f ront cover into the mounting hole of
back cover.
Installation structions
2
Select Wide lens mode
1. Unlock the switch.
2. Prize up the joint line bet-
w een fr ont and back cov er
w ith a blade screw driver.
4.1 prevent reflector from dust of drilling hole,
please remove reflector w hen mounting back
cover, avoid your hands contacting reflector’
s
surface w hen removing or mounting reflector,
only blow off them or w ipe off them slightly
w ith sof t cloth after f ounding dust not other
things for keeping better detection effect.
4.2 connect the w ires to terminal, observe
connection polarity
4.3 Don’
t let your hands contact infr ar ed
sensor.
L
TIMER
EL-208 can use in Curtain lens
detection mode, but as curtain lens
mode, must change single w ide
lens into curtain lens angle lens.
Removing the curtain reflector, please hold reflector’s top .pull emissive mirror
outwards.
When uninstalling, hold on the upper tw o sides of the mirror, pull the mirror out, follow ing phase of right
figure in opposite direction.Installation: push curtain reflecting mirror dow n into bottom rind. Please refer
to right figure .Notice: make sure the position of bottom of the
curtain reflecting mirror must absolutely f it into the bottom r ind.
Please refer to part of the figure.Horizontally push curtain reflect-
ing mirror into the detector. Please refer to right figure
Notice:
after installation, make sure the curtain reflecting mirror
is stable, don’
t touch the mirror w hen installing.
Installation
Note:
Only apply pow er after all connections are made and inspected.And make sure the pow er
polarity is correct 14-22AWG w ire is recommended.
Note:Do not leave too long w ire in the detector.
Terminals V+&V-:
Pow er input, Voltage: 9 -16V.The max
distance is up to 250m/750feet betw een the detector and pow er
source if using w ire #22AWG.
Terminals C&NC:
Alarm output. 30VDC/150mA. Max
Terminals T1&T2:
Tamper output, N.C, 24VAC/500mA.
12V/DC
Zoom
Input
Control Panel
V +
V-
C
NC
T 1
T2
Terminals
EOS
Resistor
GND
30cm
60cm
80cm
8M
>1M
Note:
please install the
detec tor on w all, the
plac e s hould be one
meter or higher.
Ｆｏｒ ｃｕｒｔａｉｎ ｌｅｎｓ
Ｆｏｒ Ｐａｔｉｏ
Ｆｏｒ ｗｉｄｅ ｌｅｎｓ