3
www.topvehicletech.com
FITTING GUIDE
FASCIA PLATE SET-UP
1. Take the new fascia and place it into the dash where the OEM radio used to sit, once placed correctly,
screw into place using the factory screws.
3. With the cage secured into place, and once the “
Stereo Installation
” process is complete, simply slide
the stereo into the fascia.
2. Take the pocket and install it into the preferred aperture (most commonly this is installed within the
bottom port).
1. Open the passenger side door and proceed to pull away the door trim from the pillar.
STEREO REMOVAL
DAB ANTENNA INSTALLATION
2. Using a set of panel removal tools, begin to pry away the pillar casing.
4. The DAB antenna not only has a self adhesive backing, but also features a black earth sheet. When
placing the DAB antenna, the earth sheet
MUST
be placed onto the metal part of the pillar. The antenna
itself must be located roughly 15cm from the top of the windscreen.
Note: this antenna must not be placed atop any kind of heating elements, this will interfere with the
antenna’s signal.
5. Once happy with the placement, take the 3m of wiring extension and feed it down through to the
stereo’s opening. With the wiring adjusted to the appropriate length, feel free to re-install the glovebox.
3. The glovebox will need to be dropped down to route the antennas wiring. To do this, first remove the
glovebox side panel. Then remove 3x screws located within the lip of the glovebox, as well as 3x located
underneath. Once free, pull out and drop down into the footwell.
1a. Use a panel removal tool to release the air cone unit and remove 2x screws located here (this step is
only required for
Volkswagen Golf
vehicles).
1b. Use a panel removal tool to remove the trim surrounding the main radio. This will reveal 4x screws
which will need to be removed.
2. Once free, pull the head unit out of the dashboard and disconnect all of the wiring in the process.
