Top Gun 205 LCD, Manual Manual

Page: 18 / 26

14
The default value of inductance is 10, it is recommended to keep this value unless the operator is an experienced welder.
5. Press the Right Button (4) again to return to the main wire speed/voltage adjustment screen. If the control
panel is not adjusted after 5 seconds it will also return to the primary MIG adjustment mode. Or press the
Left/Right (1)/(3) to return to the primary MIG adjustment mode directly.
6. During welding the screen display will change to show the actual welding voltage and welding current as
pictured below
7. 2T/4T function: press the Right Button (4) ,2T/4T Selection Switch to move between 2T and 4T modes. 4T
operation means the trigger is pulled once to start welding and pulled again to stop. This is useful for long
weld joints. 2T mode, the trigger must be depressed and held during welding.
8. Wire check function: press the Right Button (4) again to enter to the wire check mode, rotate Right knob (3)
to select ON/OFF
Feeding the wire
1. Remove the conical nozzle (24) and the welding tip (25) from the torch. The conical nozzle is removed by
turning clockwise and pulling off simultaneously. The welding tip threads out of the tip adapter.
2. With the wire feed cover door still open pull the torch trigger (20) and check that the wire is feeding
smoothly through the feed roller and into the torch
3. Now stretch the torch lead and handle out as straight as possible from the machine and select the wire
check function. This will start the feed motor running at full speed to feed the wire through the torch liner.
Actual Welding
Voltage
Actual Welding
Current