TOP CNC
Machine No: DB1802020101
Machine Model: TC-1631A
16
1. Transmission Reducer Adjustment:
(1) Open the two side covers of the y axis motors and remove then remove secondary covers.
(2) Loosen 4 orthogonal hex bolts and the 5
th
hex bolt which can be seen from the bottom
opening of the reducer gear box. The gap can be adjusted by pushing hard to the direction of
the rack. (Note: do not strike the object with the weight when adjusting.)
(3) Tighten all 5 hex bolts and replace both covers.
(4) Run the machine to test the alignment.
2. Cleaning
(1) Clean up the dust, dirt and dirt on the guide, rack, screw and so on in time so as not to affect
the use of the machine
(2) After the removal of the dirt, the lubricating oil should be added. (Note: liquid lubricants less
than 1500SC)
(3) The surface of the rack also needs to be cleaned regularly and coated with antirust or
lubricating oil to prevent rust, generally half a month for a cycle.
(4) Check the tightness of the synchronous belt and adjust it in time. (Note: standard within
2mm of winding degree)
(5) Machine with a refueling device, oil marking: N32 mechanical oil.
Maintenance list
Sequence
number
Component
Content
Cycle / Time
1
Air-cooling spindle
Ensure spindle appearance is neat running smoothly/quietly.
everyday
2
Air-cooling spindle
If abnormal spindle sound or high spindle temperature please
turn off your air and check to ensure all air lines are free of
debris.
everyday
3
Vacuum/Air/Debris
Lines
Ensure all air lines, vacuum lines, and debris lines are free from
blockage.
everyday
