9
/
14
12
. Assembly drawing
12.1 Assembly drawing
12.2Note
：
12.2.1 When you dismantling the turret must be marked relatively position
of the assembly and do not attained sealed ring of the turret.
12.2.2 When you reassembling the turret it is must be make sure the fixing
surface is clean and have not dust or other material.
12.2.3 When you adjused coder at frist must be lock the turret at any
position and set an approximate positioning by rotating the unit to get the
corresponding position code or the signal passes from 1 to 0 and mark this
new position and tighten the screws of the fixing pieces.
