CAUTION: Do not operate this device with open cover!
b) Replacing the fuse
If the lamps burn out, chances are the fuse on the rear panel might too. Only replace the fuse
with a fuse of the same type and rating (see technical specifications at the end of this user
manual). For the installation, you need one 3A/250VAC (3A/125VAC) fuse.
Procedure:
1)
Unscrew the fuse holder with an appropriate screwdriver
2)
Remove the old fuse and replace it by the new one
3)
Replace the fuse holder in the housing and fasten it with the screwdriver
CAUTION: Only replace the fuse with the device unplugged from the mains!
c) Mounting the device
The installation of the effect has to be built and constructed in a way that it can hold 10 times the
weight for1hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate
safety cable.
Never stand directly below the device when mounting, removing the fixture.
Procedure:
The projector should be installed outside areas where persons may reach it, walk by or be
seated.
Overhead mounting requires extensive experience, including amongst others calculating working
load limits, installation material being used, and periodic safety inspection of all installation
material and the device. If you lack these qualifications, do not attempt the installation yourself.
Improper installation can result in bodily injury.
Before mounting make sure that the installation area can hold a minimum point load of 10 times
the device s weight.
Adjust the desired inclination angle via the mounting bracket and fix the bracket screws tightly.
Connect the fixture to the mains with the power plug. In general, lighting effects should not be
connected to dimming packs.
CAUTION: When installing the device, make sure there is no highly inflammable
material within a distance of min. 0.5m!
CLEANING AND MAINTENANCE
The following points have to be considered during the inspection:
1) All screws for installing the devices or parts of the device have to be tightly connected and
must not be corroded.
2)
There must not be any deformations on the housing, color lenses, fixations and installation
spots (ceiling, suspension, trussing).
3)
Mechanically moved parts must not show any traces of wearing and must not rotate with
unbalances.
4)
The electric power supply cables must not show any damage, material fatigue or sediments.
Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.
We recommend a frequent cleaning of the device. Please use a moist, lint-free cloth. Never use
alcohol or solvents.
CAUTION: Disconnect from mains before starting maintenance operation!
TECHNICAL SPECIFICATIONS
Power supply: max. 220V AC/60Hz
Power consumption: max.280w
Fuse: F10A, 250V AC
Lamps: ELC-C 24V/ 250W
Maximum ambient temperature T
a
: 45
℃
Maximum housing temperature T
b
: 130
℃
Tong-Da Industry Co., Ltd
Company web Site : http://www.ur.url.tw/ E-mail : [email protected]
Mobile Phone : + 886-0913-933255 TEL: + 886-6-293-4039 FAX : + 886-6-295-8668
