MACHINE SETUP
UNCRATING MACHINE
CAREFULLY CHECK THE CRATE FOR ANY SIGNS OF
DAMAGE. BATTERIES ARE IN THE UNIT.
TO UNCRATE THE MACHINE, REMOVE BANDING FROM
AROUND THE CRATE. TAKE OFF THE TOP AND SIDES
AND DISPOSE OF PROPERLY. REMOVE BANDING
FROM MACHINE. REMOVE THE CHOCKS AROUND
THE DRIVE WHEELS. FOLD DOWN RAMP, AND DRIVE
MACHINE OFF OF THE BASE. NOTIFY THE CARRIER
IMMEDIATELY IF CONCEALED DAMAGE IS DISCOVERED.
CONNECTING BATTERIES
YOUR MACHINE IS EQUIPPED WITH (FOUR) 6 VOLT,
DEEP CYCLE, 396 AMP HOURS BATTERIES, WHICH
FORM A 24 VOLT SYSTEM. MAXIMUM BATTERY
DIMENSIONS ARE 7"W X 15"L X 15"H.
1. TURN ALL SWITCHES TO THE OFF POSITION AND
REMOVE KEY.
2. HINGE OPEN THE BATTERY ACCESS LID TO
ACCESS THE BATTERY COMPARTMENT.
3. ALL OF THE FOUR BATTERY CABLES ARE
CONNECTED TO THE BATTERIES. LOCATE ANY
LOOSE ONES AND CONNECT TO THE OPEN
TERMINAL. TIGHTEN WITH 9/16" WRENCH.
(SEE FIGURE 7.)
4. TURN ON MAIN POWER SWITCH AND CHECK
THE BATTERY CONDITION METER TO ENSURE
CORRECT INSTALLATION. CHARGE BATTERIES IF
NEEDED. (SEE: BATTERY CHARGING)
2. LOOSEN THE TWO WING NUTS ON THE SQUEEGEE
AND SLIDE THEM INTO THE SLOTS IN THE SQUEEGEE
MOUNTING PLATE. THE SQUEEGEE TRAIL WHEELS
SHOULD FACE OUTWARD.
(SEE FIGURE 9.)
3. TIGHTEN THE TWO WINGNUTS, AND CONNECT
VACUUM HOSE FROM THE MACHINE TO THE
SQUEEGEE.
(SEE FIGURE 9.)
4. YOU MAY HAVE TO ADJUST THE SQUEEGEE PITCH,
BY USING THE PITCH ADJUSTMENT.
(SEE FIGURE 9.)
PAGE 9
ATTACHING SQUEEGEE
1. LOWER THE SQUEEGEE MOUNTING PLATE BY
DEPRESSING THE SQUEEGEE SWITCH TO THE DOWN
POSITION.
(SEE FIGURE 8.)
FIGURE 7
FIGURE 8.
FIGURE 9.
chadv
11/23/2005 9:54:13 AM
