© Copyright 2017. All rights reserved.
TUL-01-OM-REV.1
P a g e |
1 2
Product Description
iQ Technology(Option)
The Ultralift™ is equipped with iQ Technology® that provides very useful data to assist with
maintenance, training and compliance. An explanation of these is set forth below:
Explanation of LCD Display Message
Three sets of messages are displayed depending upon the lift being in normal operation, when
a specific button is pushed or when being charged.
1. Lift On but not in Operation
:
During idle periods while lift is on, the LCD display will scroll through the following 7
indicators every 7.5 seconds:
TTL CYCL
: #### - Accumulated cycles of the lift defined as upwards travel of more than 12
inches followed by downward travel.
TTL HRS
: #### - Accumulated number of hours the lift has operated. This is defined as the
number of hours the motor (lifting and traversing) has been in operation.
CHARGES
: #### - Accumulated number of times the batteries have been charged
CHARGE PERC
: % - The current level of charge in the battery. This is displayed as a
percentage in increments of 10% from 0% to 100%.
LOW CHRG
: #### - Accumulated number of times the batteries have experienced a very
deep discharge (means lift is not being charged enough and batteries will be permanently
depleted and may cause early replacement)
SERVC IN
: #### - Number of lift cycles remaining before service is required. This resets
after service.
SERVC CHK:
#### - Indicates a switch is stuck on a hand control or touch pad.
2. Dynamic Messages. These only occur when the specific switch is pressed
.
Lift Up: #### Life accumulated number of Lift Up movements.
Lift Dn: ### Life accumulated number of Lift Down movements.