Communication manual TOHO ELECTRONICS INC.
DWG.No. 4B-6829-A
- 3 -
2.2.
Setting of Communication Protocol
Select the communication protocol.
2.3.
Setting of Format
Sets the format for each protocol. See “
Explanation about TOHO Protocol Communication
” for details.
2.4.
Setting of Device Address
Setting must be made in accordance with format setting specifications.
2.5.
Setting of Communication Speed, Data Length, Stop Bit, and Parity
Setting must be made in accordance with the settings of upper computer that shall be connected.
During the setting of MODBUS RTU, data length will be fixed to 8 bits (data length setting will be ignored).
2.6.
Setting of BCC
In case of TOHO Protocol, set “With or Without BCC Check (Turn BCC Check ON/OFF).”
2.7.
Setting of Response Delay Time
Set the
time to take for the upper computer to complete the receiving of “request message,” open the line, and get ready for the next
input.