38
Tofino Xenon Security Appliance Tofino SA
Release 04 05/2015
FAULT LED
The FAULT LED flashes during the USB save and load sequences to
convey specific messages. See the following table to interpret this activity.
No. of
flashes
During save sequence
During load sequence
1
---
The USB port is disabled. In the Tofino
Configurator, check the Communications
setting on the Tofino SA General page. The
method of communication should be "USB
Only" or "Both USB and Network".
2
No USB memory device is connected to
the USB connection, or the file system of
the memory device is not formatted as
FAT or FAT32.
No USB memory device is connected to the
USB connection, or the file system of the
memory device is not formatted as FAT or
FAT32.
3
The device was unable to create any
diagnostic files. Please contact technical
support.
The files on the USB memory device are
invalid.
4
The device was unable to encrypt the
diagnostic files. Please contact technical
support.
The device was unable to decrypt the config-
uration files. The files were possibly
damaged during the copying operation.
Repeat the copying operation. If the condi-
tion persists, contact technical support.
5
The device was unable to copy the diag-
nostic files to the USB memory device. It
is possible that the memory device is
full.
The device was unable to load the files. It is
possible that the files were damaged during
the copying operation. Repeat the copying
operation. If the condition persists, contact
technical support.
6
The device was unable to deactivate the
USB connection. Please contact tech-
nical support.
The device was unable to deactivate the
USB connection. Please contact technical
support.
7
The file system of the device does not
have enough memory capacity to save
the files temporarily before they are
copied to the USB memory device.
Please contact technical support.
---
Table 12: FAULT LED diagnostics for USB Save and Load
