again. To shut the kettle off before the boiling cycle is complete, press
the On/Off Switch to the ‘Off’ (‘O’) position.
7. If you want to use the Kettle again, allow the thermal safety switch to
cool down for 15 to 20 seconds then depress the On/Off Switch to the On
(‘I’) position. If the On/Off Switch does not remain in the On position, the
water is hot enough to use without reheating.
8. Unplug cord from wall outlet before pouring water from the Kettle. Only
grip the Kettle by the Handle as all other surfaces will be hot.
9. Return the Kettle to a heat resistant surface after use.
10.
IMPORTANT
: If the Kettle is accidently switched on when empty, the
thermostat will automatically cycle on and off to prevent the Kettle from
overheating. If this situation occurs, press the ‘O’ side of the On/Off
switch and unplug the Kettle immediately. Let the Kettle cool before refilling.
11.
DISCONNECT
the Power Cord from the wall outlet when not in use.
CARE AND CLEANING
Exterior
Use a soft, damp cloth to clean the exterior. DO NOT use abrasive cleaners.
Dry exterior thoroughly before use. DO NOT IMMERSE KETTLE OR POWER
BASE IN WATER OR OTHER LIQUID.
Installing the Filter
Install the Filter before filling the Kettle with water. NOTE: NEVER REMOVE
OR INSTALL THE FILTER WHEN THE KETTLE IS HOT.
The filter must be inserted in the Kettle so that the tab is at the top and the
notch is facing down. Fit the notch onto the hook at the bottom of the spout.
Gently push on the tab until it snaps into position in front of the spout. To
remove the Filter, push the tab down and toward the center of the Kettle,
then lift out.
4
TJK-100 Book v001 7/27/04 5:18 PM Page 10
