background image

 

1. SAFETY  PRECAUTIONS

 

• Be sure to read the instructions in this section carefully before use. 
•  Make  sure  to  observe  the  instructions  in  this  manual  as  the  conventions  of  safety  symbols  and  messages 

regarded as very important precautions are included. 

• We also recommend you keep this instruction manual handy for future reference. 

 

Safety  Symbol  and Message  Conventions

 

Safety symbols and messages described below are used in this manual to prevent bodily injury and property 
damage  which  could  result  from  mishandling.  Before  operating  your  product,  read  this  manual  first  and 
understand the safety symbols and messages so you are thoroughly aware of the potential safety hazards. 

 

 

WARNING

 

Indicates  a  potentially  hazardous  situation  which,  if  mishandled,  could 
result in death or serious personal injury. 

 

When Installing the Receiver

 

•  Do  not  expose  the  unit  to  rain  or  an  environment  where  it  may  be  splashed  by  water  or  other  liquids,  as 

doing so may result in fire or electric shock. 

• Use the unit only with the voltage specified on the unit. Using a voltage higher than that which is specified 

may result in fire or electric shock. 

•  Do  not  cut,  kink,  otherwise  damage  nor  modify  the  power  supply  cord.  In  addition,  avoid  using  the  power 

cord in close proximity to heaters, and never place heavy objects -- including the unit itself -- on the power 
cord, as doing so may result in fire or electric shock. 

• Avoid installing  or mounting the unit  in  unstable locations, such as  on a  rickety table  or a slanted surface. 

Doing so may result in the unit falling down and causing personal injury and/or property damage. 

• To prevent lightning strikes, install the unit at least five meters away from a lightning rod, and yet within the 

protective range (angle of 45°) of the lightning conductor. Lightning strikes may cause a fire, electric shock 
or personal injury. 

• Since the unit is designed for in-door use, do not install it outdoors. If installed outdoors, the aging of parts 

causes the unit to fall  off, resulting in  personal injury. Also,  when it gets  wet with rain, there is a danger of 
electric shock. 

 

When the Receiver is in Use

 

• Should the following irregularity be found during use, immediately switch off the power, disconnect the power 

supply plug from the AC outlet and contact your nearest TOA dealer. Make no further attempt to operate the 
unit in this condition as this may cause fire or electric shock. 
·  If you detect smoke or a strange smell coming from the unit. 
·  If water or any metallic object gets into the unit 
·  If the unit falls, or the unit case breaks 
·  If the power supply cord is damaged (exposure of the core, disconnection, etc.) 
·  If it is malfunctioning (no tone sounds.) 

•  Do  not  place  cups,  bowls,  or  other  containers  of  liquid  or  metallic  objects  on  top  of  the  unit.  If  they 

accidentally spill into the unit, this may cause a fire or electric shock. 

• Do not touch the unit's antennas during thunder and lightning, as this may result in electric shock. 
 

When the Microphone or the Transmitter is in Use

 

• To  prevent  the  electromagnetic  wave  from  badly influencing medical equipment, make sure to switch 

off the unit's power when placing it in close proximity to the medical equipment 

 

 

 

 

 

Summary of Contents for WM-422

















Reviews: