Toa WM-290 Operating Instructions Download Page 4

TYPICAL FREQUENCY RESPONSE

RELATIVE

 RESPONSE

 IN

 dB

FREQUENCY IN HERTZ

• FCC license requirement

The operation of the TOA wireless microphone sys-
tems must conform with the rules and  regulations
contained in the code of Federal Regulations, 47,

Telecommunications, Part 74 and Part 90.  These

regulations are available  from the U.S.  Government

Printing  Office.

• D.O.C.  (CANADA)license requirement

The Department of Communication (D.O.C.) recom-

mends wireless microphones operating  in the  174  ~
216 MHz band be licensed on the following basis:

1) on a no-protection non-interference basis;

2) frequencies  shall be selected and assigned form

within television channels 7 to 13 (174 ~ 216 MHz);

3) operational  areas  shall be restricted to locations

that are at least 8 miles outside the Grade B
contour of television stations that operate on the

channel in which the frequency assignment falls;

4) location of operation to be shown on license; and
5) licenses shall  resolve  interference complaints that

result from  microphone operation.

WM-290 US version

FCC Part 90

169.445 ~171. 945MHz

± 0.005%

15mW

FCC Part 74

174 ~ 216MHz

± 0.005%

15mW

WM-291 CA version

D.O.C.

174 ~ 216MHz

0.005%

15mW

WM-290 UK version

MPT1345

173.8 ~ 175.0MHz

± 10kHz

Less than 2mW

WM-290 AS version

DOC 60
202.1 ~ 203.7MHz
0.002%

15mW

± 40kHz Deviation

± 15kHz Deviation

±

 40kHz Deviation

± 15kHz Deviation

*Specifications are subjects to change without notice.

Accessories:

Microphone holder
Color identification labels
Operating instructions

1
1
1

TOA Corporation

KOBE, JAPAN

133-07-065-30

Versions

Regulations
Carrier Freq. Range

Freq. Stability
RF Carrier Power
Effective Radiated Power

Input Level

Modulation (Max.)
Tone Freq.
Controls
Battery

Current Drain
Battery Life

Battery Indicator
Antenna

Ambient Temperature

Colour

Dimensions
Weight

128 ~144dBspl

± 15kHz Deviation

32.768 kHz

Power ON/OFF
LR6 (1.5 Volts) Alkaline
90mA Typ. (1.5V)
More than 12 hours

Green and Red LED's
Internal Dipole

–10

0

C~50°C(14°F~122°F)

Dark Gray
Ø51 x 238mm (Ø2.01" x
390g (0.858 Ibs. ) with ba

9.37")

ttery

SPECIFICATIONS

Summary of Contents for WM-290

Page 1: ... hours or more on one alkaline battery LR6 1 5V Two battery indicators green and red Internal LD signal generator for tone squelch Stopper to prevent the fall of a battery case Compressor expander system noise reduction cir cuit USER PRECAUTIONS Take care not to drop the unit on to a hard floor Do not flip nor blow into the microphone head Avoid placing the unit in areas of extremely high humidity...

Page 2: ...he green battery indicator lights 3 Set the on off switch to OFF after use and verify that the green LED is extinguished SENSITIVITY SETTING The maximum input sensitivity of this microphone can be set in the range of from 128 dBspl to 144 dBspl Factory preset to 136 dBspl If the user s mouth is put exteremely close to the microphone andspeaking loud into the microphone the amplifier is overloaded ...

Page 3: ...empt to install an antenna high above the floor 8 Once a wireless system is installed actually move around the site with a microphone to check system operation 9 Color Identification Labels Identification labels of different colors are supplied with the wireless microphone to simplify confir mation of microphone frequencies when multiple microphones are in use Attach one of the labels to the micro...

Page 4: ...wn on license and 5 licenses shall resolve interference complaints that result from microphone operation WM 290 US version FCC Part 90 169 445 171 945MHz 0 005 15mW FCC Part 74 174 216MHz 0 005 15mW WM 291 CA version D O C 174 216MHz 0 005 15mW WM 290 UK version MPT1345 173 8 175 0MHz 10kHz Less than 2mW WM 290 AS version DOC 60 202 1 203 7MHz 0 002 15mW 40kHz Deviation 15kHz Deviation 40kHz Devia...

Reviews: