SPECIFICATIONS
Enclosure
Bass-reflex type
Box Tuning Frequency
65Hz
High Frequency Level
Control
0 ~ - 10dB (with an OFF position)
Power Handling Capacity
Low Frequency
Continuous pink noise: 120 watts RMS
(Band-limited 50Hz ~ 1kHz)
Continuous program: 360 watts
Mid/High Frequency
Continuous pink noise: 80 watts RMS
(Band-limited 1kHz ~ 20kHz)
Continuous program: 240 watts
Input Connector
4P screw terminal
Speaker
Low Frequency
Mid Frequency
High Frequency
Nominal Impedance
Sensitivity
Frequency Response
12 " (30cm) dia. cone speaker
CD horn (90° horizontal by 40° vertical) plus
compression driver
Horn type
Low frequency: 8 ohms
Mid/High frequency: 16 ohms
Low frequency: 98dB (1W/1m)
Mid/High frequency: 106dB (1W/1m)
60Hz ~ 20kHz
Crossover Frequencies
Low to Mid frequency (Frequency dividing network):
1kHz, - 12dB/octave (Butterworth)
Mid to High frequency (built-in passive network): 10kHz
APPEARANCE AND DIMENSIONAL DIAGRAM
CONNECTION DIAGRAMS
890"(226mm)
1. SF-60 single system (2-way multi-amplifier driving system)
630”
317"(80.5mm)
INPUT PANEL
view from A
Low
frequency
input terminal
Mid/High
frequency
input terminal
l
Input terminal of the SF-60 is divided into Low and
Mid/High frequencies as the SF-60 is a 2-way multi-
amplifier driving system.
Be sure to connect polarities (+ , -) of each amplifier
output cord to the speaker terminals correctly.
l
Make the level setting according to the environmental
conditions, although almost flat frequency response is
obtainable as long as the High frequency level control is
set to NORMAL.
Weight
86 lb (39kg)
Finish
Polyester in gray color
Specifications are subject to change without notice.
2. Combination system with the super-woofer
(Sway multi-amplifier driving system)
Mixer/Preamplifier
dividing
I
network
I
Power amplifier
SW-46W-UL2 SW-36W-UL
SW-46S-UL2 SW-38S-UL, etc
FREQUENCY DIVIDING NETWORK
Set each mode of the frequency dividing network as per the
following tables. Best frequency response is ensured, as time
and phase are corrected with the built-in passive circuit.
1. SF-60 single system
2. Combination system with the
(2-way multi-amplifier driving
system)
*1 - 5dB stands for a standard value when
connected
to the same amplifiers for LOW
and HIGH frequencies Make the level
setting according to the environmental
conditions at installation.
super-woofer (3-way multi-
amplifier driving system)
*2 The crossover between LOW and MID
frequency range stands for a typical one
When Slope characteristics are changed,
best characteristics are obtainable by
changing phase of LOW frequency range to
normal. Decide the final change at the time
of measurement or test listening
INSTALLATION
L type metal brackets with
W3/8" nuts are provided at
four corners inside the
enclosure as shown in the
figure. Nuts are located just
at back side of the fixing
holes of the enclosure.
Utilize these fixing holes
according to the speaker
location. Refer to appearance
diagram on the fixing holes.
L type metal
brackets with
W3/8” nuts.
