Generally speaking, there are two rules to follow when connecting equipment o u t p u t s
to the inputs of other equipment.
1. Properly match the impedances of the outputs and inputs.
2. Connect low impedance outputs to high impedance inputs.
It goes without saying that not only input and o u t p u t impedance matching, but also
level matching should be taken into consideration. Each input channel of the
MX-401
is provided with an Input Level Control that includes a negative feedback (NF)
circuitry, so the usable signal level range is wide. Input impedances and levels are
shown in the following table.
INPUT SPECIFICATIONS
*Sensitivity is the level required to produce a program out level of +4dB.
*0dB is referenced to 0.775V RMS.
All XLR Type connectors are electronic balanced. Phone jack is unbalanced.
If the line going from one piece of equipment to another is long (more t h a n 5m), we
recommend that balanced outputs be connected to balanced inputs.
As is described in the beginning of the Operating Instructions Manual, t h e connectors
of the
MX-401
are wired as follows: Pin 1 is ground (shield). Pin 2 is cold (low, m i n u s ) .
Pin 3 is hot (high, plus).
— 6 —
CONNECTION
CH1
CH4
A U X
GEQ
P W R / A M P
INPUT
LOW Z
H I G H Z
ACTUAL
LOAD
IMPEDANCE
OPEN
27k
30k
50k
10k
FOR USE
WITH
NOMINAL
50
TO 250
MICRO-
PHONES
27k
OR
LOWER IMP
LINES
30k
OR
LOWER IMP,
LINES
50k
OR
LOWER IMP,
LINES
10k
OR
LOWER IMP,
L I N E S
SENSITIVITY*
(PGM OUTPUT
LEVEL +4dB)
-60dB (0.78mV)
-35dB (13.8mV)
-20dB (77.5mV)
+4dB (1.23V)
+4dB (1.23V)
CONNECTOR
XLR TYPE NC3F
PHONE J A C K
RCA PIN J A C K
P H O N E J A C K
PHONE J A C K
PHONE J A C K
Input Connections
All manuals and user guides at all-guides.com
