M-164E
17
Adjusting levels
After turning on the power, adjust the level of each
input signal. The following explanation assumes that the
STEREO OUTPUTS
are being used as the main outputs.
1 Prepare headphones or an amplification system to
output the sound in advance.
If monitoring with headphones, raise the volume
with the
PHONES LEVEL
knob slightly.
If monitoring with an amplification system, raise the
input level on the amp slightly.
2 Turn the MONITOR section
ST
switch ON (push
switch in).
With this set, the level of the signals output from the
STEREO OUTPUTS
jacks is shown on the
MONITOR
meters.
3 Raise the ST (stereo) fader to the 0 position.
4 For the channel 1–6 inputs, adjust the
TRIM
knob for
the channel so that the “0” indicator on the channel
level meter lights when a signal is being input that is
at the loudest level ordinarily expected.
For the channel 7–16 inputs, adjust the level at the
sound source so that the “0” indicator on the channel
level meter lights when a signal is being input that is
at the loudest level ordinarily expected.
Input channel
level meter
4 − Using the mixer
M-164E
M-164E
M-164E
M-164E
