Toa DLAWM-5270 Instruction Manual Download Page 4

133-07-241-5A

12. SPECIFICATIONS

Microphone Element 

Dynamic microphone unit, cardioid pattern

Modulation Frequency 

modulation

Frequency Range 

692 – 865 MHz (692 – 806 MHz for USA/Canada) 

Selectable Channel 

64 frequencies (the number of channels may differ from country to country.)

RF Carrier Power

Less than 50 mW 

Tone Frequency

32.768 kHz

Oscillator

PLL synthesized

Maximum Input Level

142 dB SPL 

Maximum Deviation

±40 kHz 

Audio Frequency Response

80 – 15,000 Hz 

Dynamic Range (AF Circuit)

More than 95 dB (with WT-5800)

Battery LR6 

(AA)

Battery Life 

More than 10 hours (alkaline)

Indicator

Power/Battery lamps 

Antenna

Built-in type

Operating Temperature 

–10 to +50°C

Finish Dark 

gray

Dimensions 

ø48 x 244 mm

Weight 

340 g (with battery)

Note:

The design and specifications are subject to change without notice for improvement. 

• Accessories

Microphone holder (with stand adapter) ............... 1
Screwdriver for setting (housed in the body) ........ 1

Storage case  ........................................................ 1
Rolling stopper  ..................................................... 1

License requirement

Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.

11. NEW EMPHASIS CIRCUIT ON/OFF SWITCH

The WM-5270 incorporates an improved new Emphasis circuit that further suppresses noise.
The Emphasis circuit can be switched to the new circuit (pre-compressor Emphasis) by setting the New
Emphasis circuit ON/OFF switch to ON (H position), and to the conventional circuit (post-compressor
Emphasis) by setting the switch to OFF (L position).
When using the WM-5270 with the switch set to ON, also reset the WT-5800 series tuner to a new circuit by
means of the optional RW-4800 ROM Writer. So, further noise suppressed and clearer sound can be assured.
The WM-5270 is compatible with the WT-4800 series turners when shipped from the factory (New Emphasis
circuit ON/OFF switch: OFF). Once the switch is set to ON, however, no more compatibility is ensured. 
The table below shows the compatibility between the Wireless Microphones and Tuners.

WM-5270

New Emphasis circuit 
ON/OFF switch: 

      ON (H)

WT-5800 
series

WT-4800 series

Pre-compressor (New Emphasis circuit)

Post-compressor 
(Conventional Emphasis circuit)

New Emphasis circuit 
ON/OFF switch: 

      OFF (L)

: Compatible

Wireless Tuners

Wireless Microphones

[Compatibility table]

H

L

H

L

Summary of Contents for DLAWM-5270

Page 1: ... the instructions in this section carefully before use Make sure to observe the instructions in this manual as the conventions of safety symbols and messages regarded as very important precautions are included We also recommend you keep this instruction manual handy for future reference 2 GENERAL DESCRIPTION The TOA s WM 5270 Wireless Microphone employs a dynamic microphone with high input handing...

Page 2: ...osed to seawater To clean use a dry cloth When the unit gets very dirty wipe lightly with a cloth damped in a dilute neutral cleanser then wipe with a dry cloth Never use benzine thinner or chemically treated cleaning towel Avoid using a mobile telephone near the wireless microphone in use Noise could be picked up When using two or more wireless microphones keep them at least 50 cm away from each ...

Page 3: ...tuner Step 2 Hold down the power switch for one second or more to turn on the power Then confirm the green LED of the Power Battery lamps will light Step 3 Hold down the power switch for one second or more to turn off the power after use 10 OPERATIONAL HINTS The microphone s service distance is 3 120 m When the microphone user moves in a facility signal dropouts momentary losses of signal receptio...

Page 4: ...ce and 2 this device must accept any interference received including interference that may cause undesired operation 11 NEW EMPHASIS CIRCUIT ON OFF SWITCH The WM 5270 incorporates an improved new Emphasis circuit that further suppresses noise The Emphasis circuit can be switched to the new circuit pre compressor Emphasis by setting the New Emphasis circuit ON OFF switch to ON H position and to the...

Reviews: