2. GENERAL DESCRIPTION
The C-CV102-CS Color Camera is a high-resolution surveillance camera equipped with a 1/4" CCD. It is designed to operate on 12 V DC, which is
supplied by an external power supply unit. The CS mount permits the optional lens that is the most appropriate for each application to be selected.
(1) Lens connector
(2) Back focal length
adjustment ring fixing screw
(3) Iris control
(4) Power input terminal
(12 V DC)
(5) Video output terminal (BNC)
(6) Mode setting switch
(7) Camera mount
(8) Camera mount fixing screw
(9) Back focal length
adjustment ring
(10) Camera mount fixing hole
H
IRIS
L
12V
OFF
ON
SHUTTER
BLC
AWB
F.ADJ
VIDEO OUT
ATW
1
2
3
4
5
6
7
8
9
10
O
Note
Fixing holes (10) are provided in both the top and bottom panels.
Camera mount
Ceiling panel
Camera mounting bracket
(optional)
Lock lever
Pedestal
Wall
Camera mounting bracket
(optional)
Camera mounting bracket
(optional)
Wall
[Ceiling mounting example]
[Wall mounting example]
1
3
2
4
Pin No.
1
2
3
4
Lens connector
Pin name
Damping coil
Damping coil
Driving coil
Driving coil
3. HANDLING PRECAUTIONS
• Do not direct the camera lens to the sun or strong lighting or light
reflection.
• Do not give the camera a great shocks or vibration, as this will
damage the camera.
• It is recommended that the camera be always used in locations
where the ambient temperature ranges from -10°C to +50°C and
humidity levels of less than 90% to ensure that no condensation is
formed.
• To clean, wipe with a dry soft cloth. Never use benzene, thinner or
chemically processed towel as the unit's plastic or other parts may be
deformed or discolored.
• When dust has settled on the camera's lens, lightly clean using a
commercial camera blower or cleaning paper.
• Installing the camera cables in close proximity to fluorescent lamps
or other electrical appliances can downgrade the picture quality. In
such cases, change the wiring.
• If there is a strong electric or magnetic field near the camera, such as
television transmission antennas, motors or transformers, this may
distort or roll the monitor picture. In such cases, run the entire wiring
route through metal conduit tubing.
• Use the external power supply unit of the following rating.
12 V DC, over 0.5 A
4. NOMENCLATURE
5. INSTALLATION
Install the unit only in a location that can structurally support the
weight of the unit and the mounting bracket. Doing otherwise
may result in the unit falling down and causing personal injury.
WARNING
1. Attach the lens to the camera.
• Insert the lens into the camera’s lens mount and rotate to full stop.
• Connect the connector from the lens to the lens connector.
Note
DC drive type lenses can be used, however Video type lenses cannot
be used.
