CHAPTER 1: Installation
Make sure the heads are positioned approximately the same height as the
license plate and separated by at least 24 to 30 inches from each other. Being
too close together can cause interference.
Use the included green bubble level tool to make sure the heads are
horizontally positioned, and are facing straight forward, and ensure all torque
screws are tight.
When using a third head, install the head in the center of both heads,
below the car’s emblem or directly above the license plate.
The CPU computer has a capability of having 8 heads total
with an optional splitter.
Make sure
transponders
are facing
straight forward.
Make sure the heads are
horizontally installed by using
the bubble level included in
the package.
Changing the Lens cover
After a year of use on the road, replace
the old lens cover with a new one. Use
a pin to pry open the old lens cover to
replace it.
Cables
Arrows on cable align for
proper fit.
Optional third head for maximum protection.
BMW owners have the option to install the heads vertically. However a third
horizontal head is required so you have two vertical outside heads and one center
horizontal head.
4
5
Controller is installed inside the cabin.
24” ~ 30”
a-15
UDT
AUTO/QUIET
RCV
a-15
UDT
AUT
O/QUIET
RCV
a-15
UDT
AUTO/QUIET
RCV
a-15
UDT
AUTO/QUIET
RCV
24” ~ 30”
a-15
UDT
AUT
O/QUIET
RCV
a-15
UDT
AUTO/QUIET
RCV
