Hold the camera head .Slip the semicircle end of the accessory over the flats of camera head . Then rotate
the accessory 90°to fix.
• Accessories installation for camera head
9mm
Install the accessories by screw thread. Please put on the thread protector if no need for accessories;And
take off the protector when you need to install accessories.
4.2. Operation methods
4.3. Operation Precautions
• Please read the safety instructions carefully, choose desirable work area for fear causing danger.
• The probe is flexible to help you operate in hard-to-reach areas. Please don’t insert or bend by force.
Please do not over bend any part of the probe. Normally, the bending radius should more than 5cm to
prevent from causing permanent damage to the probe.
• Don’t use the probe or camera head to modify surroundings, clear pathways or clogged areas. It couldn’t
be used as a fishing rod or tape.
• The camera head and its cover are waterproof, but not acid-proof or fireproof. Don’t touch with these
materials or they will ruin the camera head’s protective plastic. Avoid submersing the camera head into
corrosive, oily places or high-temperature objects.
• Don’t place the inspection into anything or anywhere that may contain a live electrical charge. Please
check following methods to avoid injury.
For walls: For inspecting the inside walls, be sure to shut off the circuit breaker to the whole house before
using the tool.
For pipes: If you suspect a metal pipe could contain an electrical charge, have a qualified electrician to
check the pipe before using. A ground circuit, in some cases, can be returned to the cast aluminium pipes
and cause them to be charged.
For automobiles:Be sure the automobile is not running during inspection. Metal and liquid under the hood
may be hot. Don’t get oil or gas on the imager head.
5. Operation notes
• Please don’t operate this product unless the manual has been read and proper training has been com-
pletely.
• Please allow at least 2 seconds between each ON and OFF for the unit to properly boot up and shut
down. If the image is not normal, please shut off the product and power on again.
• Please be sure to shut off the image software firstly, then turn off the product and pull out the cable
before turn off your computer, which could avoid computer crashed.
• Don’t use sharp objects�metal or liquid to touch the signal connector in order to avoid short circuit or
product damage.
• Don’t let any object compress the signal cable, or placed the signal cable in a humid places.
• Don’t place the signal cable on places where people often walk in order to avoid being damaged.
• Don’t immerse the grip into water, which will result in electric shock and damage.