S
AFETY
I
NSTRUCTIONS
•
Please keep this Operation Manual for future reference. If unit is sold to another user, make sure they also
receive this instruction booklet.
•
Ensure fixture is connected to proper voltage, and that line voltage is not higher than that stated on the fixture.
•
Make sure there are no flammable materials close to the unit while operating.
•
Always disconnect from the power source before servicing or fuse replacement. Always use the fuse specified
in this manual.
•
Always use a safety cable when hanging fixture overhead.
•
Maximum ambient temperature (Ta) is 40°C (104°F). Do not operate fixture at temperatures above this rating.
•
In the event of a serious operating problem, stop using the unit immediately. Repairs must be carried out by
trained, authorized personnel. Contact the nearest authorized technical assistance center. Only OEM spare
parts should be used.
•
Do not connect the device to a dimmer pack.
•
Make sure power cord is never crimped or damaged.
•
Never disconnect power cord by pulling or tugging on the cord.
•
Avoid direct eye exposure to the light source during operation.
Caution! There are no user serviceable parts inside the unit. Do not open the housing or attempt any
repairs yourself. In the unlikely event your unit may require service, please contact your distributor.
F
USE
R
EPLACEMENT
Mozart Drive PortableMount: 4A, 250V, slow-blow, 5x20mm (0.2x0.8 in.)
Mozart Drive RackMount 2U: 12A, 250V, slow-blow, 6x30mm (0.24x1.18 in.)
Mozart fixtures have no fuse.
To replace fuse:
1) With a screwDriver turn the fuse cap counter-clockwise to remove fuse cap with fuse.
2) Replace fuse attached to fuse cap.
3) Reinsert fuse cap with new fuse and tighten clockwise.
M
OUNTING
/R
IGGING
–
M
OZART
D
RIVE
P
ORTABLE
M
OUNT
Orientation
The Mozart Drive PortableMount may be mounted on truss or pipe, in any position, using
the yoke supplied with the unit. Always make sure there is adequate room for ventilation.
Rigging – Always consult a certified rigging engineer before suspending any fixture
overhead!
Use ProBurger
®
couplers or equivalent C- or O-type clamps for attaching to truss. After establishing
the desired position, retighten both knobs.
•
Always use safety cables!
•
When selecting installation location, consider routine maintenance.
•
Never mount Mini enclosure where it will be exposed to moisture, high humidity, extreme
temperatures, or restricted ventilation.
Please read these instructions carefully. This user guide
contains important information about the installation, usage and
maintenance of this fixture.
Disconnect the power cord before replacing a fuse
and always replace with the same type fuse.
Summary of Contents for SOLARIS MOZART UV
Page 11: ...Mozart Drive RackMount 2U...