DMX data LED has two states: Glowing red and flashing orange.
If there is no DMX signal, the Input LED will glow red. If there is an incoming DMX,
the LED will flash green and orange.
Input/Output LEDs indicate signal level or fault conditions:
Operation
Each mode coverts either DMX to 0-10V or 0-10V to DMX control. 0-10V inputs are
numbered 1-4 at the bottom of the unit and correspond with sequential DMX
addresses depending on the set starting address. DMX starting address can only be
changed via RDM compatible controllers.
For Example:
If the DMX starting address is 1, then each 0-10V input/output will correspond with
exactly the same DMX address as follows:
•
0-10V Input/Output #1 corresponds with DMX channel 1
•
0-10V Input/Output #2 corresponds with DMX channel 2
•
0-10V Input/Output #3 corresponds with DMX channel 4
•
0-10V Input/Output #4 corresponds with DMX channel 4
If DMX starting address is 37, then each 0-10V input/output will correspond with the
DMX starting address in sequence:
Summary of Contents for ProPlex PP010VCDIN
Page 3: ...Dimensions...
