172-65639M-01 (EF200) 13 Apr 2018
58
Mating pipe diameter Enter actual value of the mating pipe to activate the diameter
mismatch correction.
Setting range: 0 to 1 m
Factory setting: 0 m
Installation factor
Enter factor to adjust for installation conditions. (Positive
floating point number)
Factory setting: 1.0
8.2.16 Totalizer 1 to 3: Setup
→
Advanced setup
→
Totalizer 1 to 3
See 8.2.4 ‘Totalizer handling’
Descriptions of functions: Totalizer 1 to 3
Assign process
variable
Select process variable for totalizer.
• Off
• Volume flow
• Corrected volume flow
• Mass flow
• Total mass flow
• Condensate mass flow
• Energy flow
• Heat flow difference
Factory setting: Depends on customer specifications.
Unit totalizer
Select units for the process variable assigned to totalizer.
NOTE: Available units may differ depending on selected
process variable.
Factory setting: Depends on customer specifications.
Failure mode
Define totalizer behavior in alarm condition.
• Stop
• Actual value
• Last valid value
Factory setting: Stop
8.2.17 Display: Setup
→
Advanced setup
→
Display
NOTE: Parameters that appear in 8.2.8 have been omitted here.
Parameters that have not been explained in 8.2.8 are described below.
Descriptions of functions: Display
Decimal places
1 to 4
Select the number of decimal places for the display value.
• x
• x.x
• x.xx
• x.xxx
• x.xxxx
Factory setting: x.xx
Language
Set display language.
See 8.2.1
Factory setting: English
Display interval
Set time measured values are shown on display if display
alternates between values.
Setting range: 1 to 10 seconds
Factory setting: 5 seconds
Display damping
Set display reaction time to fluctuations in the measured value.
Setting range: 0.0 to 999.9 seconds
Factory setting: 5 seconds
Header
Select header contents on local display.
• Device tag
• Free text
Factory setting: Device tag
