1
FIGURE 3
LAMP INSTALLATION
CAUTION
: Always handle quartz halogen lamps with
a soft cloth. Do not touch the lamp with your bare
hand as it will shorten the life of the lamp.
(1) Do not touch the floodlight while it is in use or still
hot. Allow it to cool before touching it.
(2) Do not use halogen lamps rated higher than 150
watts for SEC150 and 500 watts for SEC500.
(3) Disconnect the power cord or wall switch.
Unscrew retaining screw at the top of the unit.
This will release the front surround.(FIGURE 4)
(4)
FIGURE 4
(5) Raise front surround. Lift off retaining
lugs.(FIGURE 5)
FIGURE 5
(6) Unwrap the halogen lamp, taking care that the
fingers do not touch the glass. Push one end into
either of the spring loaded sockets. Locate
other end on other socket and release.(FIGURE
6)
FIGURE 6
2
(7) Carefully replace front surround making sure that
the seal is correctly positioned. Screw up firmly.
(FIGURE 7) DO NOT OVER TIGHTEN.
FIGURE 7
INSTALLATION
To facilitate installation select a location for the unit
based on the coverage angles shown in FIGURE 8.
UNIT(M)
COVERAGE ANGLES
FIGURE 8
Install a wall switch adjacent to the power source.
(FIGURE 9) This helps
you operate with ease. See
Operation for further information.
FIGURE 9
WIRING INSTRUCTION
(1) Switch off the power source.
(2) Remove the mounting bracket from the floodlight.
Drill the wall and screw the bracket onto the wall
using suitable plastic wall plugs and screws.
Check that the bracket is securely fitted on the
wall.
Note: Do not at this stage re-attach the
floodlight to the bracket.
