8
Control Room
•
Frequency Response:
10-30KHz ± 0.5dB
•
Distortion:
≤0.05%
•
Signal to noise ratio:
≥93dB
•
Signal to noise ratio (MM):
-75dB
•
MM gain:
39dB
•
Dimensions:
(L x W x H): 340x290x160mm
•
Weight:
12 KGs
•
Vacuum Tube:
12AX7x4, 12AT7x1,
6P6P x 1,5Z3Px1
Specifications are subject to change without notice.
Specification
TLA
udio
®
by
FATMAN
Engine Room x 2
•
The Power Output:
200W
•
Frequency Response:
20Hz~20KHz±0.5dB
•
Harmonic distortion:
≤2%
•
Signal-to-Noise Ratio:
≥90dB
•
Input impedance:
100Kohm
•
Input Sensitivity:
500mV
•
Output impedance:
0ohm, 4ohm, 8ohm
•
Power Supply:
AC100~120V/50~60Hz
AC220~240V/50~60Hz
•
Dimensions:
(L x W x H) 380X390X185mm
•
Weight:
51kgs
•
Vacuum Tube:
KT88x12, 6N8Px4,ECC88x2
Specifications are subject to change without notice.
If your Mothership fails to operate normally, please check the following points to determine if the fault can be corrected
with one of the simple suggestions below. If you feel your unit is still faulty after reading this, please contact your
authorised dealer or service centre.
SYMPTOM
- Unit fails to turn on with
POWER switch
- No Sound.
- No sound is heard from
one / both speakers.
- The acoustic image is
unstable.
POSSIBLE CAUSE
- Power adaptor is not connected properly.
- Mains supply is off.
- The volume control is set to the fully
counter-clockwise position.
- Connection cords are not connected
securely to the INPUT terminals.
- Speakers are not connected properly.
- Speakers are not properly connected.
- The signal input is not properly connected.
- The positive and negative polarities of the
unit and speakers are not matched.
REMEDY
- Make sure power is
firmly plugged in.
- Turn clockwise.
- Connect securely.
- Connect securely.
- Connect correctly.
- Connect correctly.
- Re-connect correctly.
Troubleshooting
Mothership Manual UK.qxd 10/25/07 9:25 AM Page 8
