T. Kverneland & Sønner AS,
Kvernelandsvegen 100
N-4355 Kvernaland
Norway
E-post : [email protected]
Phone : +47 51 77 05 00
8
www.tks-as.no
7
70
10
25
25
25
40
10
Kutt
6
Removing the wire end:
• When the wire has been tightened, the long end must be removed.
• Before clipping, you
MUST
wrap the wire.
• Without wrapping, strands will be pulled into the wire rope and it will be
damaged in a very short time.
• Put 3 wraps beside the cut location. Use the enclosed iron wire (1.0 mm
thick wire).
• Make the wrap by winding the wire over one of the ends.
• Twirl the ends and tighten – ensure that the twirl does not break.
• Wind tape outside the wraps
• Cut the wire rope in the centre of the tape.
• Tie the end of the wire rope with the wire wraps
Startup / running:
• Thighten the tension in the wire, until the spring measures 60mm
• Mount the scraper to the tensionrod
• The most preferred mounting place for the scraper, is at the same place
on the wire as it was dismantled.
• Run the scraper back and forth 5 times manually.
• The FeedBelt system will automatically
fi
nd end-positions, and the wire
will adjust accordingly.
• Check
tension.
Service and maintenance:
• Inspect wire every week.
• Clean wire if neccessary
• Rust must be removed and area must be recovered with oil immediately
• Apply oil on wire. TKS Spraycan (item no. 923054)
• Wire must be regreased/oiled minimum once pr. year, or when needed.
• In hazardous areas with high humidity or corrosive atmosphere, take
extra precautions with inspctions, cleaning and re-greasing.
• Pay extra attention if feeding with wet silage.
• For additional information about FeedBelt see :
www.tks-as.no http://tks-as.no/dokumentasjon/category1043.html
