1
4
Max
mm
a
b
2
3
RIKTIG
GALT
4
a
a
b
5
0,6 m
80
120
80
b
a
IMPORTANT!
Read the whole instructions and do the following in the set order:
• Faults and damage caused by not following these instructions will
NOT
be
covered by the TKS warranty.
• If transport damage is discovered on wires before installation,
please contact TKS.
DO NOT
fi
t wires without end caps
(a)
or wraps
(b)
Preparation:
• Place the rake at the
fi
lling end.
• Damaged wire must be removed.
• Retain the wire clips to
fi
t new wires.
Control:
• Wire discs; drives/reverses, must be checked for damage before
installation.
• Use the attached feeler gauge to see whether there is wear on the discs.
• Max 4 mm
gap from the tip of the feeler gauge to the bottom of the disc.
• Discs must be replaced if they are seriously damaged.
Handling:
• Be careful when handling wires.
• Wires must not be drawn out from the end of the reel.
Tightened snags damage the wire permanently.
• The reel is placed on a storage stand on which it can rotate.
• The wire must be unwound from the reel horizontally.
• Very
important!
Unwind the wire from the bottom reel to the bottom disc.
(Alternatively, from the top reel to the top disc).
• Keep the wire taut when unwinding.
• Avoid gravel and sand on the steel rope. This will a
ff
ect the service life of
the wire.
• NB!
Joining new and damaged wires for pulling is
NOT permitted.
Installation:
• Place the reel at the
fi
lling end and unwind the wire from the
bottom of the reel.
• Insert wire end
(a)
into the guide blocks.
• Wind the wire around the turn disc.
• Pull the wire towards the drive disc.
• Pull the wire completely o
ff
the reel.
• Wind the wire end
(b)
around the drive disc.
• Form a loop at end
(b)
120 mm free end outside the wire clip.
• Tighten the rope and place the loop on end
(a)
approx. 0.6 m away from
the
fi
rst loop.
• Fit the wire clip and tighten.
• Tighten the wire using the tightening tool and screw the clip tightly to the
tightening rod.
• See the Assembly instructions for FeedBelt for detailed instructions
988865
CORRECT
WRONG
Assembly instruction – wire
FeedBelt
