FITTING INSTRUCTIONS
Product:
T13 Outback Frontal Protection System
Vehicle:
Ford Ranger PXII, PXIII (Non-Tech pack), Everest (UA model only)
Part No.
070SB13N20A
For product warranty please refer to our website www.tjm.com.au
F-12114
Page 6 of 27
03/01/2019
12.
On both sides of the vehicle, release the
plastic inner guard from the bumper,
discarding all of the fasteners.
13.
Remove bumper to fender screw both sides
and retain.
14.
Disconnect any wiring harnesses secured to
the bumper.
15.
Carefully remove the bumper leaving the
templates in place for marking at step 19.
16.
Remove and retain the OE front underbody
guard and associated fasteners.
17.
Remove center lower bumper support brackets
at lower air dam position.
18.
Remove and discard the front intrusion beam
using the following steps:
18.1.
If radar is fitted,
remove and
retain mount
bracket with
radar in place for
later installation.
18.2.
Remove and retain the front intrusion
beam fasteners (4) from the indicated
locations.
18.3.
Remove and discard the clips on the
lower plastic air guides.
RHS SHOWN
STEP 18.1
STEP 18.2