FITTING INSTRUCTIONS
Product:
T13 Outback Frontal Protection System
Vehicle:
Mazda BT50
Part No.
070SB13L46E
For product warranty please refer to our website www.tjm.com.au
File: F-5002
Page 10 of 19
25/01/2021
36.
Using the indicated hole as a guide, drill a
Ø6mm hole in the trimmed air guides.
37.
De-burr the edges & clean the area/surface of
any swarf/debris, then (if applicable) treat any
raw exposed surfaces with a rust preventative.
38.
Secure the trimmed lower air guide in place
(as shown), using an M6 x 1.0 x 20mm hex
bolt (1), M6 x Ø23mm flat washer (1), M6 x
Ø18mm flat washer (1) & M6 nyloc nut (1).
39.
Repeat steps 36 through to 38 for the
opposite side of the vehicle.
40.
Mark the upper air guide as shown, following
the below process:
40.1.
Mark a point along the contour line,
65mm from the front lower corner of the
upper air guide.
40.2.
From the point previously marked, mark
a line up to the forward edge of the
bend above.
40.3.
From the point previously marked, mark
a vertical line down to the lower edge of
the upper air guide.
41.
Following the previously marked trim lines,
trim the upper air guide to shape.
RHS SHOWN
STEP 36
RHS SHOWN
65mm
STEP 40.3
STEP 40.2
STEP 40.1
