FITTING INSTRUCTIONS
Product:
T13 Outback Frontal Protection System
Vehicle:
Mazda BT50
Part No.
070SB13L46E
For product warranty please refer to our website www.tjm.com.au
File: F-5002
Page 8 of 19
25/01/2021
22.
Mark the lower air guide as shown, following
the below process:
22.1.
Mark a horizontal line on the front face
10mm (approx.) above the rounded
mounting point.
22.2.
Mark a vertical line on the side face,
20mm from the flat front face.
22.3.
Join the two lines previously created
with a horizontal line on the side face.
23.
Following the previously marked trim lines,
trim the left hand lower air guide to shape.
24.
De-burr the edges & clean the area/surface of
any swarf/debris.
25.
Repeat the previous three steps for the
opposite side of the vehicle.
26.
With the nuts towards the center of the
vehicle, insert the inner chassis nut-plate into
the large opening in the front of the chassis
rail, having the thin “leg” towards the rear of
the vehicle & touching the bottom inside face
of the chassis rail.
27.
Align the holes in the inner chassis nut-plate
with the holes in the chassis rail.
28.
Position the chassis brace on the outer face of
the chassis rail (as shown), aligning the
respective holes with the inner chassis nut-
plate, then loosely secure it in place, using
M12 x 1.25 x 40mm hex screws (3), M12
spring washers (3) & 1/2” x Ø1
-
1/4” flat
washers (3).
29.
Repeat steps 26 through to 28 for the
opposite side of the vehicle.
LHS SHOWN
STEP 22.2
STEP 22.3
STEP 22.1
RHS SHOWN
THESE TWO
HOLES ALIGN
RHS SHOWN
