FITTING INSTRUCTIONS
Product:
T13 Outback Frontal Protection System
Vehicle:
Mazda BT50
Part No.
070SB13L46E
For product warranty please refer to our website www.tjm.com.au
File: F-5002
Page 12 of 19
25/01/2021
49.
Following the previously marked trim lines,
trim the plastic inner guard to shape.
50.
De-burr the edges & clean the area/surface of
any swarf/debris.
51.
Repeat steps 44 through to 50 for the
opposite side of the vehicle.
52.
Mark the plastic inner guard, following the
below process:
52.1.
From where the lower edge of the wheel
arch body guard meets the plastic inner
guard, mark a horizontal trim line along
the plastic inner guard, across to the
first contour.
52.2.
45mm down from the previously marked
trim line, mark a parallel trim line.
52.3.
Along the first contour on the plastic
inner guard, mark a trim line, joining the
two previously marked trim lines.
If fitting to a pre-2015 model year face
lift, follow steps 53 to 55. Otherwise,
proceed to step 56.
53.
Unclip and discard the trim piece from the
bumper as shown.
RHS SHOWN
BUMPER
45mm
RHS SHOWN
TRIM PIECE
