FITTING INSTRUCTIONS
Product:
Outback & Fleet Frontal Protection System
Vehicle:
Toyota 70 Series 09+
Part No.
Ente 070SB13F69G 070SB13L69G 070SB13O69G 070SB15W69G 070SB15Z69G
For further information contact T.J.M. Head Office on (07) 3865 9999. Distributors Australia wide.
File: 88700
Page 7 of 12
22/08/2017
18. Adjust the fog lights so they are
positioned in the center of the pressing
and are projecting forward.19
19. Separate the indicator / park light body
from the backing plate.
20. Secure the backing plate to the FPS,
using the screws provided with the
light assemblies.
21. Supporting the backing plate, re-fit
(clip) each indicator / park light body
(ensuring that an adequate seal is
achieved.
22. If a winch is to be fitted, fit it now
following the instructions supplied with
the winch.
During winch installation, refer to
Steps 23-29 for installation of the
specially designed, 70 Series Kill
Switch Bracket (F-2715) and the Kill
Switch (Supplied with Winch).
If a Deluxe FPS is being fitted, use
the 6 holes in the rear of the winch
frame to secure the winch wiring.
23. Carefully remove and retain the TJM
ON/OFF sticker.
070SB13L69G SHOWN