TJERNLUND DRYER DUCT BOOSTER LB2 Quick Start Manual Download Page 1

DESCRIPTION & PURPOSE

The LB2 is Listed to the updated DEDPV, Dryer Exhaust Duct Power Ventilator supplement to UL705 & CSA C22.2 #113-12. The 2015

IRC restricts the use of dryer booster fans to those tested to the DEDPV supplement. Incorporating dryer booster fans in clothes dryer
ducts has increased substantially with the placement of laundry rooms not adjacent to outside walls. Duct runs often exceed 25 equiva-
lent feet (each elbow equates to five additional feet of duct length) that many manufacturers set as a maximum duct length. The LB2
booster fan is rated for duct lengths up to 150 equivalent feet.

SPECIFICATIONS & COMPONENTS

INSTALLATION RESTRICTIONS 

This product has rotating parts, do not plug into power if duct is not connected on both ends of Dryer Duct Booster®.

The installation must comply with local electrical and mechanical, fuel gas, or building codes, and must be inspected and accepted by
local authorities having jurisdiction.

CAUTION:

DO NOT INSTALL IN AN EXHAUST DUCTWORK OF A CLOTHES DRYER WHOSE INSTRUCTIONS PROHIBIT THE

INSTALLATION OF A CLOTHES DRYER BOOSTER FAN.

ATTENTION:

NE PAS INSTALLER DANS LE CONDUIT D’ÉVACUATION

DE LA SÉCHEUSE SI LES INSTRUCTIONS INTERDISENT L’INSTALLATION D’UN VENTILATEUR AUXILIAIRE.

CAUTION:

DO NOT INSTALL IN AN EXHAUST DUCTWORK WHERE THE EQUIVALENT DUCT LENGTH IS LESS THAN OR

EQUAL TO 7.62 METERS (25 FT). 

ATTENTION:

NE PAS INSTALLER DANS UN CONDUIT D’ÉVACUATION MESURANT 7,62

MÈTRES (25 PI) DE LONGUEUR OU MOINS.

The Dryer Booster Fan must be accessible after the installation is completed.

This Dryer Booster Fan may not be used in conjunction with dryers designated as high output.

WARNING

- If a blinking or solid Red LED is displayed on the Notification Panel turn off clothes dryer and reference “Dryer Booster Fan

Notification Panel Status Lights” section of these instructions.

WARNING - TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:

1) Your clothing dryer installation incorporates a dryer exhaust duct power ventilator (DEDPV) which may be in a different location than 

your dryer, such as in an attic, crawl space or basement.

TJERNLUND PRODUCTS, INC.

1601 Ninth Street • White Bear Lake, MN 55110-6794
PHONE (800) 255-4208 • (651) 426-2993 • FAX (651) 426-9547
Visit our web site • www.tjernlund.com

READ OWNERS INSTRUCTIONS CARE-
FULLY PRIOR TO INSTALLATION. SAVE
THESE INSTRUCTIONS. 

IMPORTANTES POUR LA SÉCURITÉ.
CONSERVEZ CES INSTRUCTIONS.

DRYER DUCT BOOSTER® FAN 

MODEL LB2

MODEL LB2

Blower:

160 cfm

Motor:  

115 Volts ~ 60 Hz
0.80 amps maximum

Impeller:

Reverse inclined, particulate handling

Components: (1) LB2 wired fan assembly

(1) Notification Panel
(1) 16 gauge galvanized steel mounting bracket
(1) mounting hardware packet

©2015 TJERNLUND PRODUCTS, INC.  ALL RIGHTS RESERVED

P/N: 8504216

For Residential Capacity Clothes Dryers

UL705
CSA C22.2 #113-12

WARNING

!

14"

 10.5"

OUTLET

INLET

4"

 10"

6.25"

FIGURE 8061040    1/19/15

4"

Summary of Contents for DRYER DUCT BOOSTER LB2








Reviews: