- 15 -
15
feeder mechanism clean. fasteners.
Lubricate ”O” rings that
are replaced.
Assure long life and
proper operation of
tool.
Use lithium grease or
equivalent.
Use only recommended
replacement parts.
Keep tool operating
efficiently.
Order any replacement
parts needed from local
service center dealer.
OPERATOR TROUBLESHOOTING
,
!
CAUTION
,
!
Disconnect the tool when performing
repairs.
PROBLEM
CORRECTIVE ACTION
T-nuts will not drive completely into
wood.
Increase air pressure (do not exceed 120
psi).
T-nuts penetrate properly during normal
operation, but won’t drive fully at faster
speeds.
Increase air flow to tool-use larger air lines
(3/8 inch ID minimum).
T-nuts drive too deeply into wood.
Reduce air pressure.
Tool can’t fire.
Check magazine for proper T-nuts. T-nuts
should slide freely with no follower
pressure.
Increase air pressure (do not exceed 120
psi).
Air leaks at cap when tool is connected to
air.
Tighten cap screws.