4
Guide to Features (Front Panel):
1.
ALARM: Once you have set the wake-up time using the Alarm Thumbwheel, push this button in
to activate the alarm and the corresponding green LED will light. The LED will remain lit until the
Alarm button is turned off. Push the Alarm button out to deactivate the alarm and the LED will
extinguish. This Alarm button controls the Dual Alarm Speaker only and has no affect on the Model
Three clock radio’s alarm, and vise-versa. See “How to set the alarm” for more information.
2.
ALARM THUMBWHEEL: Rotate the aluminum thumbwheel counterclockwise until the Alarm
hand points to the designated time you wish to wake to.
Do NOT turn the Thumbwheel clock-
wise or you may damage the mechanism. See “How to set the Alarm” for more information.
3.
SNOOZE (Top of Cabinet): When the Alarm sounds, press, hold, and then release the Snooze
button to silence the Alarm for approximately 5 minutes. After 5 minutes, the alarm will auto-
matically resume. This Snooze button controls the Dual Alarm Speaker only and has no affect
on the Model Three clock radio’s alarm or radio. Likewise, the Model Three’s Snooze button
will not affect the Dual Alarm Speaker’s alarm tone. The snooze time is not adjustable.
4.
CLOCK: This quartz analog clock features a fine mechanical quartz movement for superb
accuracy. The clock operates off of a single “AA” battery so power failures will not affect the
clock’s accuracy. Check the battery annually so the clock remains accurate. The clock’s illumi-
nation cannot be turned off or adjusted. It is normal for the light to take take several seconds to
extinguish if the power supply is disconnected.
Guide to Features (Rear panel):
1.
CONNECTING CABLE: Connect the male RCA from this cable to the Model Three clock radio’s
rear female RCA output marked “R-SPR” and switch to Stereo. Set the Model Three’s rear
Balance Control to the center detent position for equal balance between the two speakers.
Connecting a speaker other than the Tivoli Audio Dual Alarm or Stereo Speaker will void your
warranty and possibly damage your unit.
2.
12VDC, 10mA: Connect the included AC power supply to this input. Use only the power supply
provided with this product. To obtain a replacement, contact your authorized
dealer. The power supply connector is 5.5mm/2.1mm x 13mm long, center positive.
Do not connect the power supply to an electrical outlet controlled by a wall switch.
It is normal for the power supply to become warm during use. An optional 12VDC
nominal, 2A fused source may also be used.
3.
TIME SET: Briefly press and release this button to advance the hands in small increments. Press
and hold this button to continuously advance the clock’s hands. Release the button when the
clock is set properly. Be sure the alarm button is in the Off position when setting the time. See
“How to set the clock”.
4.
ALARM GRILLE: The alarm beep emits from this grille. Do not block this grille.
5.
BATTERY BACK UP: Remove the battery cover and install a fresh major brand 1.5V “AA” battery,
observing c/– polarity. The clock operates off of the battery continuously
and the battery also acts as a back up. In the event of a power failure, the battery
back up will maintain the clock’s operation and sound the wake-up tone if the alarm
button is in the On position, provided a fresh battery is correctly installed. The clock
face will not illuminate and the radio will not operate during a power failure in order
to conserve battery life. Check the battery’s strength annually and replace only with a major
brand, 1.5V “AA” alkaline battery. If the clock stops operating, replace the battery. To reduce the
