ADNM
DTV NEMA 3 (TV Studio Camera Flicker Free)
www.tivolilighting.com tel: 714-957-6101 fax: 714-427-3458
Page 5 of 6
Copyright © Tivoli 07/08/20
Tivoli, LLC. reserves the right to modify this specification without prior notice.
CAUTION: The device may only be connected and installed by a qualified electrician. All applicable
regulations, legislation and building codes must be observed. Incorrect installation of the device can
cause irreparable damage to the device and the connected LEDs.
12V - 48V DC IN
To connect the driver to a 12-48V DC power
supply unit (PSU), connect the PSU’s positive
voltage supply wire to the VDC+ connector and
the PSU’s negative voltage supply wire to the VDC
connector. The driver and LEDs can use the same
PSU.
EXT In
You have the possibility to connect an external
control device (10 Ω potentiometer or show
selection switch) to the driver’s Ext in+ and Ext
in- connector. Configure the driver for use with
an external control device over the 3-button
user interface.
DA+ / DA-
Use these connectors to connect the driver to a
DALI network. Always combine a DA+ and a
DA- connector for either data in-put or data
output.
DMX In/LedSync Out
Use these connectors when the driver is used in
a DMX network. For DMX in, connect the network
cable’s DMX+, DMX- and DMX shielding wire (the
in a CAT5 cable) to the DMX in+, DMX in- and
DMX in shield orange/white, orange and brown
wire in a CAT5 cable) to the DMX in+, DMX
in- and DMX in shield connector respectively.
For LedSync out, connect the network cable’s
data+, data and shielding wire to the LedSync
out+, LedSync out- and LedSync shield connector
respectively.
LED groups
Indicates the location of the connectors for your
LED groups. R(ed) represents channel 1, G(reen)
represents channel 2, B(lue) represents channel
3 and W(hite) represents channel 4. The default
group color allocation can be changed over the
3-button user interface.
