Titanium 88660, Instruction Manual

Page: 6 / 12

Fig. 6
Fig. 7
5
4
2
6
3
8
7
1
1
6
EN
•
Press the pulse mode button on the top of the laser level
to enter into pulse mode. The pulse mode indicator LED
will light up.
• Switch the detector on by pressing the power button.
The speaker will beep indicating the detector is
operating.
• Move the detector into the path of the laser beam.
•
Hold the detector upright for horizontal beams (Fig. 6).
Rotate the detector 90° for vertical beams (Fig. 7).
• The LED direction indicators will indicate the position of
the laser beam. The centre LED will indicate alignment
with the beam.
USING THE DETECTOR
MOUNTING TO A TRIPOD
The Titanium TML-D3H (89110) detector
and clamp can be purchased from your
nearest Titanium dealer.
A tripod can be purchased from your nearest
measurement tool dealer. The below instructions are
generic only and set-up methods may vary between
models. Refer to the documentation from the tripod
manufacturer for details.
i
i
DETECTOR OVERVIEW
DETECTOR OPERATION
1 Bubble vial
2 LED direction indicators
3 Power button
4 Power LED indicator
5 Sound on / off button
6 Sound LED indicator
7 Laser sensor
8 Speaker
NOT INCLUDED
NOT INCLUDED
!
WARNING! Attaching the laser to a
tripod without the correct thread size
may cause damage.
• Extend the tripod legs to the required height and
ensure the legs are spread wide enough so that
the tripod platform is stable. Secure the legs in
place (refer to the documentation from the tripod
manufacturer for details).
• Place the laser level onto the tripod and mount via
the male thread (5/8” or 1/4”) into the base until firm.
Do not over tighten as this may cause damage to
the laser level or tripod.
NOTE: adjustment methods will vary on tripod models.
Always ensure that any locking levers are unlocked
before making adjustments and returned to the locked
position when the adjustment is complete.
• If using an elevating tripod with a measuring scale on the
centre column, the height can be adjusted as required.