Titanium 88190, Instruction Manual

Page: 5 / 12

Fig. 1
5
Charging the rechargeable battery pack
• Attach the desired adaptor head onto the charger.
• Insert the charger into the charging port located on the
battery pack and underneath the control panel. Progress
will be shown by the power indicator display on the
charger as following:
Red (flashing) = Charger and battery
are not connected.
Red (constant) = Battery is charging.
Green (constant) = Battery is charged.
• Charging time is approximately 5 hours for
a depleted battery.
The battery pack does not need to be inserted in the
laser level whilst charging via the port on the battery
pack.
Removing and inserting the rechargeable battery
pack or alkaline battery pack
• Loosen the battery pack screw on the front of the laser
level below the control panel and slide the battery pack
out. If the screw is tight, loosen with a screwdriver.
• Insert the battery pack, ensuring the metal pins are
aligned. Tighten the battery pack screw. For better
weather sealing, use a screwdriver to tighten.
WARNING! Do not attempt to
disassemble the battery pack.
!
i
USING THE LASER (continued)
EN
i
HORIZONTAL MEASUREMENT SETUP
Level surface set up
•
Select a place as close and practical to the work site as
possible, and ensure that the location is clear of traffic.
• Place the laser level onto a reasonably level surface with
the lighthouse facing upwards.
VERTICAL MEASUREMENT SETUP
Level surface set up
• Select a place as close and practical to the work site as
possible, and ensure that the location is clear of traffic.
•
Place the laser level onto a reasonably level surface with
the control panel facing upwards.
OPERATION
Powering on
• Press the
power button once and the laser level
will power on and begin automatically self-levelling.
When this levelling process is complete, the penta prism
inside the lighthouse will start rotating.
•
If the laser level is outside the self levelling range the
laser level will not level causing the laser beam and self-
levelling icon on the remote control to flash continuously.
If this occurs, reposition the laser level onto a level
surface until the laser level can level off.
In bright outdoor conditions, visible distance will
be significantly reduced. For outdoor use, it is
recommended to use the included detector.
Powering off
• Press the
power button once and the
laser level will power off.
Speed control
• Press the
speed control button on the laser level or
remote control to cycle through various rotational speeds.
• The selected speed will be displayed on the speed
control indicators on the laser level control panel and on
the remote control LCD screen.
Scanning mode
• To focus the laser beam between two points, press the
scan mode button on the laser level or remote control.
• Pressing the button multiple times will adjust the angle of
the beam. The scan angle will be displayed on the remote
control LCD screen.
• To cancel scan mode, press the scan mode button
several times to cycle through to full rotation or power
the laser level off and on again.
Rotation direction
• Whilst the laser level is in scan mode, press
the grade adjustment / clockwise rotation or grade
adjustment / counter clockwise rotation button on the
laser level or remote control to change the rotation of
the laser head.
0
X
Y
300
600
1000