EN
25
In
more
detail...
TTI827HDC
by TITAN
Troubleshooting
Troubleshooting
Suspected malfunctions are often due to causes that the users can fix
themselves. Therefore check the product using this section. In most cases the
problem can be solved quickly.
WARNING!
Only perform the steps described within these
instructions!
All further inspection, maintenance and repair work must be
performed by an authorised service centre or a similarly qualified
specialist if you cannot solve the problem yourself!
Problem
Possible cause
Solution
1. Product does
not start
1.1. Battery pack is not
properly attached
1.2. Battery pack is
discharged
1.3. Battery pack is damaged
1.4. Other electrical defect to
the product
1.1. Attach properly
1.2. Remove and charge
battery pack
1.3. Check by a specialist
electrician
1.4. Check by a specialist
electrician
2. Product does
not reach full
power
2.1. Battery pack capacity
too low
2.2. Air vents are blocked
2.1. Charge battery pack
2.2. Clean the air vents
3. Unsatisfactory
cutting result
3.1. Blade is worn / damaged
3.2. Thickness of branches
exceeds capacity
3.1. Replace with a new one
3.2. Only cut branches
complying with the
capacity
4. Product
suddenly
stops
4.1. Battery pack is
discharged
4.2. Battery pack is too hot
4.3. Cutting device is blocked
4.1. Remove and charge
battery pack
4.2. Remove battery pack
and let it cool down
4.3. Remove blockage
5. Excessive
vibration or
noise
5.1. Blade is dull/damaged
5.2. Bolts/nuts are loosen
5.1. Replace with a new one
5.2. Tighten bolts/nuts
