10
GB
IE
G
e
tt
in
g s
ta
rt
e
d
..
.
11
Install the extension tables
GB
IE
Screw the additional legs (20) to the rear legs(10) with
so that they point towards the rear of the machine (Fig. 4).
Turn the table saw upright into the normal operating position.
hex screws (27), washers
(28) and nuts (29)
Fig. 4
20
24
10
Fit a screw through each of these two holes and into the corresponding tapped
holes in the table top side
Use four screws (27), washers (28) and two nuts (29) to fit the stand side
brackets(19).
Tighten the screws to secure the extension table, making sure it is aligned and
flush with the table saw.
Repeat for the second side table extension.
Use the same way to fit the rear extension table.
Fully tighten all screws once the table top and table extensions are aligned parallel
and flush together.
Fig. 5
Fig. 6
G
e
tt
in
g s
ta
rt
e
d
..
.
19
17
27 28 29
17
1
27
19
Before you start
Install the saw blade guard
1.Install riving knife
Remove the table insert with a
screwdriver.
Set the saw blade to the maximum cutting depth, move it to the 0° position and
lock it in place with the fixing handle (9). Slacken the screw (make sure the plate
under the table is not removed), then insert the riving knife into the slot.Adjust
the riving knife (5) so that the gap between the saw blade (4) and the riving knife
(5) equals 3 - 5 mm(see Fig. 7)
The riving knife (5) has to be in line with the saw blade (4) in longitudinal
direction. Retighten the screw.
Re-fit the table insert.
crosshead(PH1)
Fig. 7
Fig. 8
5
max. 3-5mm
2. Fitting the saw blade guard (Fig. 9)
CAUTION.
The saw blade guard (2) must be in position at all times to prevent
contact with the blade. It should lift up and onto the workpiece when the
workpiece is passed through the saw.
Place the saw blade guard(2) together with the screw on top of
the riving knife(5) so that the screw is snug in the oval hole.
NOTE.
The blade guard (2) should return to its rest position after the
workpiece has been sawn.
Fig. 9
2
5
being removed / tightened
Before you start
TTB554TAS by
TITAN
TTB554TAS by
TITAN
