Care and maintenance
TTB546BTS
by TITAN
28
In
more
detail…
GB
IE
Fig. 34
Fig. 35
NOTE:
The sanding belt must run in the direction of the arrow on
the smooth side of the belt. Ensure the sanding belt is centered
on the drum.
NOTE:
The tension lever (15) is spring loaded so use extreme
caution when pushing it into place.
> Install the lower belt cover (35) and fixed guard (33) in reverse procedure.
> Push the tension lever (15) back into place.
> Loosen the fixing screw (29) with the 6mm hex key. (Fig. 17)
> Then place the belt sanding body to a vertical position.
> Remove the lower belt cover (35). (Fig. 34)
> Pull out the old sanding belt (1) and replace a new one. (Fig. 35)
Pull out
Pull on
> Remove the disc guard (21) by unscrewing the screws and washers. (Fig. 36)
> Please replace the sanding disc (3) damaged or worn by a similar disc. (Fig. 37)
> Using the two screws and washers securely tighten the disc guard (21) into
place.
Replacing sanding disc
35
1
