OPERATIONS INSTRUCTIONS
Note
:
Before using the tool, read the instruction
book carefully.
INTENDED USE
This circular saw shall be used for cutting wood or similar
materials.Other uses for the tool will lead to the damage of
the tool and a series of dangers to the operator. This tool is
intended for DIY home use or occasional professional use.
1. SAFETY ON/OFF SWITCH
Your switch is locked off to prevent accidental starting.
Depress lock off button (17) then pull the on/off switch (18)
and release lock off button (17). Your switch is now on. To
switch off just release the on/off switch.
2. HAND GRIP POSITION
(Fig. 1)
Always hold your saw firmly with both hands when
operating.
3. DEPTH OF CUT ADJUSTMENT
(Fig. 2)
Hold the circular saw with the rear part facing against you.
Lift up the depth adjustment lever(15) to loose it. Hold the
base plate at the rear position and lift up the saw body until
the blade is at the right depth. Use the depth scale (16) to
determine the cutting depth. Push the depth locking lever
(15) down to lock it securely.
NOTE:
Always use the correct blade depth setting. The
correct blade depth setting for all cuts should not be more
than a full tooth of the blade teeth below the material being
cut. Allowing more depth will increase the chance of
kickback and result in a rough cut.
4. BASE PLATE ANGLE ADJUSTMENT
(Fig. 3)
Adjusting the angle of the base plate enables bevel cutting.
Loosen the base plate bevel lock button (13) and rotate the
base plate to set the bevel angle using the angle scale
(12). Then clamp the base plate position using the bevel
lock (13). Finally, check the angle and ensure the base
plate is firmly clamped. Do not use the depth of cut scale
when making bevel cuts due to possible inaccuracy.
Fig. 1
Fig. 2
Fig. 3
CIRCULAR SAW 2000W TTB287CSW
