TITAN 210MM SLIDING COMPOUND MITRE SAW TTB236MSW
ASSEMBLY
The saw must be stable and not move about
in operation. Before using, this saw must
be mounted and securely fastened to a level,
ÀUPZRUNVXUIDFH
ROTARY TABLE LOCK HANDLE
(see fig. 3)
To install the rotary table lock handle (1), place the
threaded stud at the outside of the threaded hole
and turn clockwise to tighten.
DUST EXTRACTION PORT
(see fig. 4)
To reduce build up of saw dust and maintain the
efficiency of cutting, the saw may be connected
to a workshop vacuum cleaner via the dust outlet.
A dust bag (1) is provided for use on your mitre
saw. To install it simply fit the dust bag over the
exhaust port (2) on the upper blade guard.
To empty the dust bag, remove from the dust
exhaust port. Open the dust bag by unzipping the
slide fastener.
NOTE:
To ensure optimal dust collecting,
empty the dust bag when it becomes
approximately 2/3 full.
TABLE EXTENSION ROD
(see fig. 5)
To install table extension rod, insert ends of
extensions into the holes in either or both sides
of the base. Secure them in place by tightening
the screws located in the hold down clamp
post holes.
HOLD DOWN CLAMP
(see fig. 6)
1) The Hold down clamp can be fitted on either
side of the saw and is fully adjustable to suit the
size of the workpiece.
2) Do not operate the saw without clamping the
workpiece.
3) Make sure that the hold down clamp securing
screws are tightened.
Warning
: Always check clamp position
does not interfere with any saw operation.
Before switching on, lower the saw head to ensure
the clamp clears the guard and saw
head assembly.
Fig 3
1
Fig 4
Fig 5
2
1
Fig 6
