Titan TTB085DRL, Safety And Operating Manual

Page: 6 / 11

1050W PERCUSSION DRILL TTB085DRL
TECHNICAL DATA
Rated Voltage
Rated power
No load speed
Impact rate
Drilling capacity
Steel
Masonry
Wood
Protection class
Weight
ACCESSORIES
auxiliary handle: 1pc
depth gauge: 1pc
chuck key: 1pc
230 V~ 50 Hz
1050 W
0-1100 / 0-3000 min
-1
0-17600 / 0-48000 min -1
13 mm
16 mm
32 mm
/II
3 kg
OPERATION INSTRUCTIONS
NOTE: Before using the tool, read
the instruction book carefully.
1. Installing the auxiliary handle (see A)
Slide the handle onto the drill and rotate to the
desired working position. To clamp the auxiliary
handle rotate the handgrip clockwise. To loosen
the auxiliary handle rotate the handgrip anti-
clockwise. Always use the auxiliary handle.
2. Installing the depth gauge (see B)
The depth gauge can be used to set a constant
depth to drill. To use the depth gauge, loosen the
handle by rotating the bottom section of handle
anti-clockwise. Insert the depth gauge through
hole in handle. Slide the depth gauge to required
depth and tighten fully.
3. Mounting a tool into chuck (see C)
When mounting the drill bit, insert bit between
the chuck jaws as far as it will go. Ensure drill
bit is in the center of the chuck jaws. Using the
chuck key provided, there are three holes in which
the chuck key should be inserted. Tighten them
equally in turn at each of the three holes, not
just at one hole. Your drill bit is now locked in the
chuck. The bit can be removed by reversing the
above procedure.
WARNING:
Before installing accessory,
remove plug from power supply. Do
not attempt to tighten drill bits (or any other
accessory) by gripping the front part of the chuck
and turning the tool on. Damage to the chuck
and personal injury may result.Always check
chuck key has been removed before plugging in
and starting the drill
4. Operating the On/Off switch (see D)
ON/OFF SWITCH
Depress the switch to start the tool and release it
to stop your tool.
SWITCH LOCK-ON BUTTON
Depress on/off switch then lock-on button, release
on/off switch first and lock-on button second. Your
switch is now locked on for continuous use. To
switch off your tool just depress and release the
on/off switch.
Fig A
Fig B
Fig C
Fig D