Titan TT-BW248413SZ, User Manual & Service Manual

Page: 16 / 26

Attentions:
Titan Products recommends allowing the unit to run overnight before loading with product. As warm
air rises, the temperature inside the unit tends
to be slightly warmer at the top and slightly
cooler at the bottom.
When plugged in, the unit will begin operating under the factory default settings. If the unit was
turned off during installation, simply press and the unit will immediately switch on. To turn the unit
off, press again.
Handle Installation
Open the door, carefully pull the door gasket around the area where the handle is to be installed, and remove
the two pre-installed decorative plugs from the front of the door. (Note: some models do not have decorative
plugs installed.)
Insert the Phillips head screws through the gasket side of the door and pass through the door.
Align the handle with the screws and hand-tighten use screwdriver until the handle is flush against the door
frame. (CAUTION: Do not over-tighten the screws as this may cause damage to the handle or to the stainless-
steel door.)
Carefully press the door gasket back into its original position.
!
WARNING
Improper gasket installation will
result in condensation
USER GUIDE
www.titan-appliances.com
13