Titan Data Series TS143 Owner’s Guide
11
MANUAL TRANSMISSION READY MODE cont’d
DIAGNOSTICS
If the remote starter does not activate when the Start button is pressed, the park lights will flash a
diagnostic code to indicate what shutdown input prevented starting.
PARK LIGHT FLASHES
PROBLEM
SOLUTION
3 Slow Flashes
System is in Service Mode
Cancel Service Mode
4 Slow Flashes
Door Open
Manual Transmission Models
Only
5 Slow Flashes
Ignition On
Turn Off Ignition Key
and Try Again
5 Flashes
Brakeswitch Engaged
Check Brakepedal or Consult
Dealer
6 Flashes
Hoodswitch (Hood Open)
Close Hood and/or Check
Hoodpin Switch or Consult
Dealer
7 Flashes
Tach Lock-Out/Failed Start
Start Vehicle with Key, Wait
5 Seconds and Try Again or
Consult Dealer
TRANSMITTER LEARNING
Important!
The remote starter will hold 4 transmitter codes. It is recommended that when
programming in transmitters, you fill up all four transmitter codes, even if only using one or two
transmitters. This will clear all other transmitter coding from the unit and prevent stray coding or
possible interference from other remote transmitters.
In you purchase new transmitters, they will have to be programmed to your unit before they will
function. Your local Titan dealer can do this for you, but in the event you do not have access to
a dealer, you can program them in yourself. All transmitters to be used on the vehicle must be
programmed in at the same time. If you try to add only one transmitter, when you add it, it will
erase all other transmitter in the system, so you must code in all transmitters. This is a security safety
feature in the event you lose a transmitter.
CODING IN TRANSMITTERS
1. Within 3 seconds, turn ignition key On and Off 3 times, leaving the key in the “ON” position
(On-Off-On-Off-On).
2. Press and hold the Program button on the antenna (center of windshield). The park lights will
turn “On” and the horn/siren (optional) will honk once. Continue to hold the Program button.
The park lights will turn “Off” and the horn/siren (optional) will honk 5 times quickly.
3. While holding the Program button, press and release the Lock button on each of the remote
transmitters to be programmed. If using two transmitters, code in each transmitter twice. Turn
off the key. One long horn honk will follow to show you have exited programming.
Hold
IGNITION ON
