2
OPERATION
TAMPER
1. When removing the rear cover, the tamper switch will be triggered. The trigger
command signal will be sent to the Receiver immediately.
2. If coded TITAN Chime / Alarm Receivers will sound in alarm mode for
approximately 30 seconds be silent for approximately 10 seconds, then sound
again for approximately 30 seconds. This will repeat until cancelled on the
receiver or for 10 cycles of 30 seconds.
FIGURE 3
NORMAL ACTIVATION
3. When the PIR Detector is triggered by moving heat source a radio signal is
transmitted to the Receiver to activate the receivers coded to it.
4. The time control knob is designed to control the length of time that the receiver
should is turned on. It is set from 5 seconds to 12 minutes. “T” means 5
seconds, while “+” is 12 minutes. (FIGURE 4)
FIGURE 4
5. An LED is mounted inside of the PIR Detector. The indication of LED represents
the following status:
Status
LED indication
1
PIR Detector is emitting radio
signal
Illuminating steadily
2
Low battery
Flashing every 30 seconds
INSTALLATION
As soon as the code learning procedure is completed, hold the rear cover in position
and mark the two mounting holes. Drill the holes, insert the plastic wall plugs and
screw the rear cover to the wall using the screws supplied. Offer the Detector up to
the rear cover using screws as originally supplied. (FIGURE 5)
FIGURE 5
NB:
After removing the batteries, wait for 1 minute before refitting new batteries.
NB:
After replacing the batteries wait 10 seconds for the detector to become stable.
TROUBLESHOOTING
Symptom
Possible Cause
Recommendation
Flat battery
Replace with new battery
Check if mounting location of
detector is correct
Adjust mounting location
PIR Detector not working
Radio interference
Remove interference source or
change mounting location
SPECIFICATIONS
Frequency Range
433MHz
Battery
1.5V AAA x 2
Communication Range
70 m (in an open space)
Specifications subject to change without notice
